Jansen Egeplast SLM® 3.0

The protective sleeve pipe for direct welding

Pipes are optimally protected against damage by a highly resistant PE plus protective sleeve.

Jansen Egeplast SLM® 3.0 is a multi-layered patented protective sleeve pipe system of the latest generation. When these pipes are installed by alternative methods, the protective sleeve pipe ensures a long service life and cost-effectiveness. By specifying this pipe, engineers and clients can demonstrate fault-free design.

Construction

  • Protective sleeve pipe
  • Solid wall pipe made of PE 100 RC
  • additional protection layer made of PEplus

Dimension
dn 25 - 1600 mm

Pressure grades

  • PN 10, PN 16
  • PN 25 (on request)

Application

  • Water
  • Gas
  • Wastewater
  • Industry

Installers

  • Open trench
  • Cleaning
  • Hydraulic drilling
  • Berstlining
  • Ploughing method
  • Milling method

Special feature
Weldable protection layer of PEPlus

PAS 1075 type
Type 3

Embedding when installed in the ground
Gravel or sand up to 32 mm

  • Solid wall pipe PE 100 RC with additional PE plus protection layer
  • Water pressure pipes with blue protection sleeve up to 16 bar
  • Gas pressure pipes with yellow protection sleeve up to 5 bar
  • Wastewater and industrial pipes with brown protection sleeve up to 16 bar

Jansen Egeplast SLM ® 3.0 pressure pipes
in lengths of 12 m, smooth ends

Nominal pressure Series / SDRDimensions dn
PN 108 / 1725 - 1600 mm
PN 165 / 1125 - 1600 mm

 

Jansen Egeplast SLM ® 3.0 pressure pipes
in coils of 100 m, smooth ends

Nominal pressure Series / SDRDimensions dn
PN 108 / 1725 - 160 mm
PN 165 / 1125 - 160 mm
Jansen Egeplast SLM® 3.0